Corsair Force 3 SSD Firmware 1.3.2 Download

Posted at April 29, 2024 by PCI-DB Team

Corsair Force 3 SSD Firmware 1.3.2 Description

IMPORTANT NOTES BEFORE BEGINNING YOUR UPDATE

If you are stable and do not have issues, we suggest that you do not flash your firmware.

This update is intended to not be destructive. However, we strongly urge that you back up any important data before beginning this procedure.

This update has been validated for use with Windows 7. It has not been validated with Windows Vista and Windows XP however it may work with these OS's. Users are encouraged to update the drives with Windows 7 when possible.

This update tool is intended to be run with the drive controller in AHCI mode. If your drive controller is not AHCI enabled and your update fails, you will need to change it to AHCI mode and also enable AHCI in your OS registry. Here is page with a guide for ENABLING AHCI.

If you have issues updating using the Microsoft AHCI driver, you may need to update using the latest driver from your drive controller manufacturer.

Our latest testing shows that this update will not work using a Marvell controller.

If your update fails using the Marvell controller, you will need to update using the chipset based drive controller on your motherboard. This applies to SATA2 and SATA3 controllers.

DO NOT at any time power off your system during this procedure.
This may “brick” your drive. After your update if you still have issues, we strongly recommend the following steps:

1. Complete clearing of the BIOS. This is a good idea after any firmware flash of any device.
2. Secure erase the SSD. For some users, cloning of the drive works, for others it does not. This may be dependent upon the cloning tool used.
3. A clean installation of the OS if you experience instability after a BIOS clearing and secure erase.

UPDATE YOUR BIOS.

As always for users with issues, we recommend that you update your motherboard/notebook to the most recent BIOS before attempting to flash your firmware. This may or may not resolve your issue but it is an excellent first step. Quite a few boards/notebooks have been given SSD specific updates over the past few months.

We have seen no issues updating directly from 1.2 to 1.3.2.

Be sure to download the correct version for your drive. Ignore any terms in the firmware file name relating to Micron, Intel, etc. This has no bearing on the upgrade. You need only match the SIGNATURE as noted in the .PDF file.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers