EVGA Z87 Stinger BIOS 1.05 Download

Posted at December 3, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	EVGA Z87 Stinger BIOS 1.05
Category	Bios
Manufacturer	EVGA
File Size	19.5 MB
Supported OS	OS Independent

EVGA Z87 Stinger BIOS 1.05 Description

Fixes:
- Fix "load previous values" function
- Fix memory TWR value setting
- Improve PCI-E compatibility
- Fix system cannot boot when setting manual CPU core

Windows Installation:

- Download the .zip file for your motherboard
- First go into your BIOS and load defaults, save and exit
- Close all open programs.
- Go into the folder where you unzipped this package and run the appropriate batch file with full administrator rights.
- For Windows XP, Vista or 7 32Bit: FPTWIN32.BAT
- For Windows XP, Vista or 7 64Bit: FPTWIN64.BAT
- Press Y in CAPITAL LETTERS to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.

NOTE:

- If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.

USB Flash/DOS Drive Installation:

- Create a bootable disk.
- Extract the above .zip file to your bootable disk.
- From a DOS prompt, run fptdos.bat
- Press Y in CAPITAL LETTERS to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, shut the system down completely. Then power on again.

Important:

- After flashing verify that the correct flash was applied by checking the version number on the lower right corner of the BIOS screen.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related EVGA Drivers