Jeti DS-16 RC Transmitter Firmware 3.00 Download

Posted at November 2, 2024 by PCI-DB Team

Jeti DS-16 RC Transmitter Firmware 3.00 Description

New features:

- Adjustable software modules for all types of transmitters. Summary table with a list of all modules is available in the menu System → Installed Modules.
- The support for telemetry controls has been added.
- Acoustic notification of the position of any proportional control.
- Digital trims can be used independently as controls for any function.

Modifications:

- Configuration files updated in the Devices folder to support 3.20 version of receivers, MVario2, and 1.20 version of the Central Box 200.
- Possibility to set the digital trim step value (Fine Tuning → Digital Trim) up to 100%. At this level the trim buttons operate in three steps (the trim values can be -100%, 0%, 100%).
- The transmitter can process and display the level on digital inputs of receivers (3.20 version), MVario2, and the Central Box 200 with 1.20 firmware version.
- The names of servos are generated from the function names. The exceptions are flap servos, aileron servos, and swash plate servos in helicopters, which are named after predefined schemes.
- In Timers/Sensors → Sensors/Logging Setup now shows the number of detected telemetry parameters from sensors (above the F(3) function button) and it is possible to reset any unnecessary entry using the F(4) button.

Update procedure for version:

- Connect TX via USB to PC.
- In the TX confirm communication with PC.
- Download the appropriate update file. Unzip its contents into a temporary folder at your hard drive.
- Copy all files from the temporary folder to the root folder of the SD card. When asked, confirm replacement of existing files.
- Switch off and switch on the TX. After that, the update will run.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers