HP ProLiant MicroServer Gen8 iLO 4 Firmware 1.32 Download

Posted at December 18, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	HP ProLiant MicroServer Gen8 iLO 4 Firmware 1.32
Category	Firmware
Manufacturer	HP
File Size	10.8 MB
Supported OS	Windows 2008 ,Windows Server 2012

HP ProLiant MicroServer Gen8 iLO 4 Firmware 1.32 Description

Fixes:
- A security vulnerability related to SSRT101323 has been addressed.
- A security vulnerability related to SSRT101336 has been addressed.
- The iLO ROM-Based Setup Utility (RBSU), which is accessed via F8 at Power On, was reduced in fit in a 64KB size limit.
- iLO allowed some ciphers other than AES/3DES to be used when the AES/3DES Encryption Enforcement Settings were enabled.
- Firmware upgrades were slow or problematic following a failed URL-based/scriptable virtual media floppy drive session.
- A boot issue might occur if embedded media was not ready during POST due to an unexpected power event.
- iLO might crash when the Import Direct DNS Name button is clicked on the Security - Single Sign-On Settings page or when a certificate is imported by using RIBCL.
- Blade servers might hang during POST if a smart component tries to cold-boot the system.
- IPMI transactions to read the power consumption from Power Supplies P/N 499250-201 might report an incorrect value of zero watts.
- CPU overheating messages could be incorrectly detected and logged in the IML and causing iLO to initiate a server shutdown.
- SSH Channel could close unexpectedly after one command is executed.
- SSH interface could lock up after multiple back to back connections.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related HP Drivers