Avaya 1608-I IP Phone SIP Firmware 1.3.3 Download

Posted at November 22, 2024 by PCI-DB Team

Avaya 1608-I IP Phone SIP Firmware 1.3.3 Description

Fixes:

- 1616-I call center phones have almost half the volume (44 db) coming out of the headset as opposed to the handset (71 db).
- 1616i type IP phones have a delay of 2sec to send the RTP to the right port.
- Handset audio improvements (noise/levels/frequency/response/compressor).
- 1603/08/16 handset audio improvements (noise/levels/frequency response/compressor).
- 1608/1616 headset volume is 5dB too quiet. Gains need a balancing for the noise improvements. Fix for the frequency response.
- 1616 non-CR headset gains need adjusting.
- 1616 handset digital gains need corrections for TIA810. Performance 
- 1603 reboots every 10 minutes after receiving HP3800 router MAC 08:2e:5f:68:1f:00
- 1616-I with BM32 continually reboots after a restart of the phone.
- 1616 IP phones with expansion button modules continuously reboots on IPO 500v2 (8.1.43/8.0.44).
- Phone restarts sometimes when receives URQ message.
- 1603 phone freezes.
- Phone is in loop of reboot when setting incorrect L2QVLAN in DHCP.
- 1608 has abnormal lamp behavior.
- 1608-I phones stop working after upgrade.
- Firmware corruption occurs during production.
- Phone reboot due to buffer allocation issue.
- Phone freezes and then reboots. Backup\Restore 
- Compatibility Backup/Restore with IIS7/7.5
- Phone does not prompt the user for new credentials when invalid credentials are entered in case of authenticated Backup/Restore with IIS-7 server
- Backup failed message is displayed on the top line for the first manual backup after the settings are cleared.
- Backup failed when all information is deleted in backup file
- For the first manual backup after reboot, screen changes from backup/restore to screen/sound.
- Phone shows strange characters in screen for entering the credentials when Phone does an automatic restore, if the BRURI points to a child folder in root folder of IIS7. Push
- 16xx phones subscribe to push server when registering in unnamed mode.
- The phone can’t receive audio push (unicast mode) from push server. Application\UI SAGE16XX-638 Redial button doesn't work on the 1616-I IP Phone after upgrading 1.3 SP2 firmware.
- The name getting cropped on the call connected screen of 1608i phone in IPO.
- Call Timer and call log not working.
- The backlight of the phone A isn’t turned off when the idle timer of incoming call on Phone A is equal to the value of BAKLIGHTOFF.
- Phone is displayed ringing status in menu and call log screen after the call is released. Security SAGE16XX-692 Do not allow DEBUG to be invoked unless PROCPSWD is nondefault. BM32 SAGE16XX-693 DND button on BM32 doesn't get activated after reboot.
- Call screening buttons on button module don't get activated after reboot. Network SAGE16XX-676 PC cannot authenticate and access network when connect to PHY2 interface of the phone.
- Phone does not send per hop trace route information under RTCP packet Subtype 5.
- RTCP packets from 16xx phone show erroneously high jitter value.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Avaya Drivers