Avaya 9608 IP Phone Firmware 6.3.1 Download

Posted at May 8, 2024 by PCI-DB Team

Avaya 9608 IP Phone Firmware 6.3.1 Description

Fixes:

- After August 2013 - World Clock feature does not display the correct data. World Online API will no longer work after August 2013, beginning September 1st a new API is required to obtain data for the World Clock
- phone feature. When using the World Clock feature on the IP phone, after API support expires and on firmware without the new API change, the user will see an error with a message: “Could not access internet service”.
- Jitter Statistics in RTCP packets do not show the correct value.
- The ringtone volume is also changed whenever the user changes the speaker volume.
- Slow internet rate for a PC which is working in 1GBps while the phone network port is connected to a 100Mbps switch port (inactive flow control).
- VPN tunnel establishment fails due to a long duration of certificate confirmation.
- Two phones which are logged in via VPN, receive the same duplicated IP address if the first two bytes of their MAC addresses are the same.
- Button module labels disappear after a network outage.
- Even though the BRURI address isn't defined in the settings file, 9608displays "retrieval failure" during login, instead of ignoring the restoreoperation. Occurs in IP Office mode only.
- Phone does not display umlauts on the third row when working as a call center agent.
- When calling back to a missed call with a 2 digits extension, the whole log of missed calls is cleared, instead of clearing only the missed call entry.
- When speaker is configured to "one way talk path", headset and handset get stuck on mute mode even though the mute LED isn't glowing.
- Phone reports incorrect uptime in SNMP query responses.
- Red and green LEDs do not function according to call states. Applies to 9608 and 9611 only.
- New LEDMODE parameter added to support different LED behavior. OLD behavior would be maintained as default (LEDMODE 0). New behavior may be obtained by setting LEDMODE to 1 (this for example will align Button module and phone LEDS in case of team button used, red led changes according to call state etc).
- If the phones are configured to work with 802.1X authentication, but the network switches are configured with "Force Authorize" (no Authentication) - then the phone will refuse to connect to the network.
- Incorrect sysuptime reported in SNMP MIB 2:(iso.org.dod.internet.mgmt.mib-2.system.sysUpTime.0)
- Chinese underscore letters in WML application are shown as strikethrough
- When changing the password on CM during an active call, the call gets dropped in case a headset was in use.
- SCEP failure timeout was increased. The phone will now allow longer time for SCEP to complete.

New Features:

- Support for 9608 Global, and 9608G

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Avaya Drivers