Gigabyte GA-EG41MF-US2H Intel VGA Driver 7.15.10.1591 for Vista Download

Posted at December 18, 2024 by PCI-DB Team

Gigabyte GA-EG41MF-US2H Intel VGA Driver 7.15.10.1591 for Vista Description

CPU   

1. Support for an Intel Core 2 Extreme processor/ Intel Core 2 Quad processor/Intel Core 2 Duo processor/Intel Pentium Dual-Core processo/Intel Celeron processor in the LGA 775 package
2. L2 cache varies with CPU

Front Side Bus   

1. 1333/1066/800 MHz FSB

Chipset   

1. North Bridge: Intel G41 Chipset
2. South Bridge: Intel ICH7

Memory   

1. 4 x 1.8V DDR2 DIMM sockets supporting up to 8 GB of system memory (Note 1)
2. Dual channel memory architecture (Note 2)
3. Support for DDR2 1066(OC)/800/667 MHz memory modules

Onboard Graphics

North Bridge:
1. 1 x D-Sub port
2. 1 x DVI-D port (Note 3) (Note 4)
3. 1 x HDMI port (Note 4)

Audio   

1. Realtek ALC888 codec
2. High Definition Audio
3. 2/4/5.1/7.1-channel
4. Support for S/PDIF In/Out
5. Support for CD In

LAN

1. Realtek 8111C/D chip (10/100/1000 Mbit)

Expansion Slots   

1. 1 x PCI Express x16 slot, running at x 16 (Note 4)
2. 1 x PCI Express x1 slot
3. 2 x PCI slots

Storage Interface

South Bridge:
1. 1 x IDE connector supporting ATA-100/66/33 and up to 2 IDE devices
2. 4 x SATA 3Gb/s connectors supporting up to 4 SATA 3Gb/s devices

iTE IT8718 chip:

1. 1 x floppy disk drive connector supporting up to 1 floppy disk drive

USB   

1. Integrated in the South Bridge
2. Up to 8 USB 2.0/1.1 ports (4 on the back panel, 4 via the USB brackets connected to the internal USB headers)

IEEE 1394

1. T.I. TSB43AB23 chip
2. Up to 2 IEEE 1394a ports (1 on the back panel, 1 via the IEEE 1394a bracket connected to the internal IEEE 1394a header)

Internal I/O Connectors   

1. 1 x 24-pin ATX main power connector
2. 1 x 4-pin ATX 12V power connector
3. 1 x floppy disk drive connector
4. 1 x IDE connector
5. 4 x SATA 3Gb/s connectors
6. 1 x CPU fan header
7. 1 x system fan header
8. 1 x front panel header
9. 1 x front panel audio header
10. 1 x CD In connector
11. 1 x S/PDIF In header
12. 1 x S/PDIF Out header
13. 2 x USB 2.0/1.1 headers
14. 1 x IEEE 1394a header
15. 1 x serial port header
16. 1 x power LED header
17. 1 x chassis intrusion header
18. 1 x clearing CMOS jumper

Back Panel Connectors   

1. 1 x PS/2 keyboard port
2. 1 x PS/2 mouse port
3. 1 x D-Sub port
4. 1 x DVI-D port (Note 3)(Note 4)
5. 1 x HDMI port (Note 4)
6. 1 x optical S/PDIF Out connector
7. 4 x USB 2.0/1.1 ports
8. 1 x IEEE 1394a port
9. 1 x RJ-45 port
10. 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line out/Microphone)

I/O Controller   

1. iTE IT8718 chip

H/W Monitoring   

1. System voltage detection
2. CPU/System temperature detection
3. CPU/System fan speed detection
4. CPU overheating warning
5. CPU/System fan fail warning
6. CPU/System fan speed control (Note 5)

BIOS   

1. 2 x 8 Mbit flash
2. Use of licensed AWARD BIOS
3. Support for DualBIOS
4. PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b

Unique Features   

1. Support for @BIOS
2. Support for Q-Flash
3. Support for Virtual Dual BIOS
4. Support for Download Center
5. Support for Xpress Install
6. Support for Xpress Recovery2
7. Support for EasyTune (Note 6)
8. Support for Dynamic Energy Saver Advanced
9. Support for Time Repair
10. Support for Q-Share

Bundle Software   

1. Norton Internet Security (OEM version)

Form Factor

1. Micro ATX Form Factor; 24.4cm x 24.4cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related INTEL Drivers