TRENDnet TEW-716BRG v1.0R Router Firmware 1.03 Download

Posted at December 23, 2024 by PCI-DB Team

TRENDnet TEW-716BRG v1.0R Router Firmware 1.03 Description

Fixes:

- Updated UPnP stealth mode functionality to prevent against UPnP scan/detection tools

Firmware Upgrade Procedures

1. Save the downloaded firmware file to your PC
2. Right click on the downloaded file and select Extract All or Extract Here option a. Make sure to remember the location where the extracted file will be saved.
3. Log into to the router’s configuration page (default IP is 192.168.10.1)
4. Click on the Maintenance and click on FW Upgrade.
5. Depending on your web browser, in the Upload Firmware section, click Browse or Choose File.
6. Navigate to the folder on your computer where the unzipped firmware file (.bin) is located and select it.
7. Click Apply. If prompted, click Yes or OK. Wait until the firmware upload completed and the device reboots.
8. To finalize the firmware update process you must reset the unit to factory default settings.
9. Log back into the interface, click on the Maintenance section. Under Restore Factory default click on Restore.

NOTE:

Firmware upgrade failure may permanently damage the unit and cause it to malfunction. Do not interrupt the firmware upgrade process by disconnecting it from the network or unplugging its power from the power outlet once the firmware upgrade process has begun. Never perform a firmware upgrade over wireless connections or via remote access connections. If the items listed in the release notes do not address an issue you are experiencing, please do not upgrade the firmware.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related TRENDnet Drivers