Billion BiPAC 7800X Router Firmware 2.32a Download

Posted at November 5, 2024 by PCI-DB Team

Billion BiPAC 7800X Router Firmware 2.32a Description

Enhancements:

1) VoIP: (VoIP models only)
1-1) Added switch control (disable/enable) for Call Waiting and 3-way Conference feature
1-2) PSTN Stutter tone now supported for MWI.
2) Added Static DNS feature
3) The scale can now be dynamically adjusted on the Bandwidth Usage page.
4) Support added for DHCP relay
5) New 3G/LTE dongles supported -- K3771, MA180 & E3276
6) Added DDNS update result (failed or successful) in the syslog.

Bugs Fixed:

1) Fixed issue whereby "RIFS Advertisement" was always set to OFF after WLAN Advanced page was applied, no matter what value user set before.
2) Resolved issue whereby the DNS Proxy daemon crashed. DNS Proxy will now be forked correctly if it terminates abnormally.
3) Fixed VoIP issues (VoIP models only)
3-1) Fails to register when there are special characters in the password field.
3.2) VoIP account needs to be re-registered when WAN IP is changed, causing VoIP call failure.
4) Some HP printers were misidentified as the 3G/LTE dongles,
5) Fixed incorrect time for Tasmania (Hobart) zone.
6) Fixed issue whereby the Regulatory Mode on the WLAN 5G Advanced page can't be changed.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Billion Drivers