SMC SMC2655W Access Point Firmware 1.4i.4 Download

Posted at December 22, 2024 by PCI-DB Team

SMC SMC2655W Access Point Firmware 1.4i.4 Description

Release History

AP Firmware (V1.4i.4):
- The AP is not reset in the case of the WEP Settings modification.
- The user can set the IP address of the Access Point with the arp –s method only during the first 3 minutes from the moment it starts up
- Fix “ power LED Flash ‘ problem.

APMG Manager (V1.71):
- Add the number of supported SMC2655W Access Point up to 128 units

Limitations & Known Issues

AP Firmware:
- The AP firmware with version 1.4 or above can’t support the old hardware T1.0, which embedded with the AP firmware version V1.3h (V1.3x series version).
- The AP supports the DHCP client function and it has been configured as the default setting. If the AP power on the network without the DHCP server, then the AP will work within the default IP address after approximate 20 seconds. 
- The AP can then be found via AP Manager after the AP starts with the IP Address.
- In wireless client, The AP Scan (discovery) function via AP Manager can’t be used to find the associated/linked AP that is located in different IP subnet.

AP Manager:
The AP Scan (discovery) function can’t be used to find the APs that are located 
in different IP subnet (segment by router) 

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related SMC Drivers