D-Link DAP-3662 rev.A1 Access Point Firmware 1.05rc047 EU Download

Posted at November 1, 2024 by PCI-DB Team

D-Link DAP-3662 rev.A1 Access Point Firmware 1.05rc047 EU Description

New Features:

1. Support CWM v1.03
2. Support Captive portal with Multiple SSID and VLAN
3. Captive portal support https URL redirect
4. Display station’s OS in client information for Captive portal client
5. One SSID with multiple schedule settings
6. MAC ACL from per SSID 64 to per radio share 512
7. Support External captive portal in CWM mode
8. Country selection for specific country code
9. Add enable/disable STP option.

Problems Fixed:

1. Fix if enable WLAN partition, blocking access from LAN to WLAN, clients does not get IP address and not have network access.
2. Fix DBG16060127->Disable AP Array if cwm is enabled.
3. Fix DBG16070013->IPv6 without need authentication could connect to internet
4. Fix DBG16070073->In WDS ping failed when configured 5G WDS with WPA/AES encryption
5. [Captive Portal]: Modify Authentication Page prompt message

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers