Foscam FI8908 IP Camera Firmware 11.14.1.46 Download

Posted at December 22, 2024 by PCI-DB Team

Foscam FI8908 IP Camera Firmware 11.14.1.46 Description

Upgrading procedure:

Step 1: Preparation before upgrading. Connect camera to router with an Ethernet cable to upgrade firmware. DO NOT upgrade firmware via wireless. Keep power on during the upgrading.
Write down the MAC address of camera. MAC address also can be found on the label of camera.

Step 2: Log into camera click For Administrator - Initialize. Click Browse - select system firmware - click Open - Click OK.

Step 3: A confirmed window will pop up after select the firmware. Please click OK to start upgrading firmware. Keep power on during the upgrading. The upgrading may take a few minutes, please be patient. Please click OK to finish upgrading.

Step 4: Firmware version can be checked on Device Information page. If the camera reboot (power off and power on again) after upgrading, the MAC address of camera will be changed to 00:01:89:11:11:05. Take the following steps a reference to change MAC address to the original one.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Foscam Drivers