MikroTik RouterOS Tile Firmware 6.38 RC 12 Download

Posted at November 22, 2024 by PCI-DB Team

MikroTik RouterOS Tile Firmware 6.38 RC 12 Description

What's new in 6.38rc12

- winbox - now Winbox 3.7 is the minimum version that can connect to RouterOS;
- crs - fixed rare kernel failure on switch reset (for example, reboot);
- dhcp - do not allow to create dhcp-server on slave interface;
- dhcp - show dhcp server as invalid and log an error when interface becomes a slave;
- dns - improved static dns entry add speed when regexp is being used;
- ethernet - optimized packet processing on low load when irq re-balance is not necessary;
- export - do not show interface comment in "/ip neighbor discovery" menu;
- firewall - do not allow to increase/decrease ttl and hop-limit by 0;
- firewall - increased max size of connection tracking table to 1048576;
- health - show power consumption on devices which has voltage and current monitor;
- hotspot - fixed nat rule dst-port by making it visible again for Walled Garden ip return rules;
- lte - allow to execute concurrent info commands;
- lte - return info data when all the fields are populated;
- routerboot - show log message if router CPU/RAM is overclocked;
- script - increment run count value when script is executed from snmp;
- snmp - provide sinr in lte table;
- trafficgen - improved fastpath support;
- tunnel - properly export keepalive value;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers