Gigabyte GA-990FXA-UD5 R5 (rev. 1.0) Marvell AHCI/RAID Driver 4.1.0.2018 Download

Posted at December 26, 2024 by PCI-DB Team

Gigabyte GA-990FXA-UD5 R5 (rev. 1.0) Marvell AHCI/RAID Driver 4.1.0.2018 Description

Specifications:

CPU:
- AM3+ Socket:
- AMD AM3+ FX processors
- AMD AM3 Phenom II processors/ AMD Athlon II processors

Hyper Transport Bus:

- 5200 MT/s

Chipset:

- North Bridge: AMD 990FX
- South Bridge: AMD SB950

Memory:

- 4 x DDR3 DIMM sockets supporting up to 32 GB of system memory
- Dual channel memory architecture
- Support for DDR3 2000(O.C.)/1866/1600/1333/1066 MHz memory modules
- Support for Extreme Memory Profile (XMP) memory modules

Audio:

- Realtek ALC1150 codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for Dolby Home Theater
- Support for S/PDIF Out

LAN:

- Realtek GbE LAN chip (10/100/1000 Mbit)

Expansion Slots:

- 2 x PCI Express x16 slots, running at x16 (PCIEX16_1, PCIEX16_2)
- 1 x PCI Express x16 slot, running at x8 (PCIEX8)
- 2 x PCI Express x16 slots, running at x4 (PCIEX4_1, PCIEX4_2)
- 1 x PCI Express x1 slot
- 1 x PCI slot

Multi-Graphics Technology:

- Support for 2-Way/3-Way AMD CrossFire/NVIDIA SLI technology

Storage Interface:

- 6 x SATA 6Gb/s connectors (SATA3 0~SATA3 5)
- Support for RAID 0, RAID 1, RAID 5, RAID 10, and JBOD
- 2 x Marvell 88SE9172 chips
- 2 x SATA 6Gb/s connectors (GSATA3 6/7)
- 2 x eSATA 6Gb/s connectors on the back panel
- Support for RAID 0 and RAID 1

USB:

- 14 USB 2.0/1.1 ports (8 ports on the back panel, 6 ports available through the internal USB headers)
- VIA VL805 chip: 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through the internal USB header)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 8 x SATA 6Gb/s connectors
- 1 x CPU fan header
- 2 x system fan headers
- 1 x power fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x S/PDIF Out header
- 3 x USB 2.0/1.1 headers
- 1 x USB 3.0/2.0 header
- 1 x serial port header
- 1 x Clear CMOS jumper
- 1 x Trusted Platform Module (TPM) header

Back Panel Connectors:

- 1 x PS/2 keyboard/mouse port
- 1 x optical S/PDIF Out connector
- 2 x eSATA 6Gb/s connectors
- 8 x USB 2.0/1.1 ports
- 2 x USB 3.0/2.0 ports
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker Out, Line In, Line Out, Mic In)

I/O Controller:

- iTE I/O Controller Chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System/Power fan speed detection
- CPU overheating warning
- CPU/System/Power fan fail warning
- CPU/System fan speed control

Form Factor:

- ATX Form Factor: 30.5cm x 24.4cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Marvell Drivers