MikroTik RouterOS Tile Firmware 6.38 RC 8 Download

Posted at November 21, 2024 by PCI-DB Team

MikroTik RouterOS Tile Firmware 6.38 RC 8 Description

What's new in 6.38rc8:

- capsman - added possibility to change arp, mtu, l2mtu values in datapath configuration;
- ipsec - changed logging topic from error to debug for ph2 transform mismatch messages;
- lte - improved dwm-222 support;
- torch - fixed aggregate statistics appearance;
- trafficgen - fixed crash when IPv6 traffic is processed;
- userman - fixed memory leak on user limitation calculations;
- winbox - removed spare values from loop-protect menu;
- wireless - fixed custom channel extension-channel appearance in console;
- switch - added hardware stp functionality for CRS devices ;
- arp - added local-proxy-arp feature;
- discovery - added LLDP support;
- firewall - added creation-time to address list entries;
- interface - do not treat multiple zeros as single zero on name comparison;
- interface - show link stats in "/interface print stats-detail" output;
- ipsec - allow to specify explicit split dns address;
- ipsec - changed logging topic from error to debug when empty pfkey messages are received;
- lte - fixed init delay after power reset;
- mobile - added support for more Vodafone K4201-Z and ZTE MF90 modems;
- rb850Gx2 - fixed pcb temperature monitor if temperature was above 60C;
- usb - fixed kernel failure when Nexus 6P device is removed;
- users - added TikApp policy;
- winbox - do not show hotspot user profile incoming and outgoing filters and marks as set if there is no value specified;
- winbox - show primary and secondary ntp addresses as 0.0.0.0 if none are set;
- wireless - added api command to report country-list ;
- wireless - fixed rare kernel failure when connecting to nv2 access point with legacy rate select;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers