MikroTik RouterOS ARM Firmware 6.37.1 Download

Posted at April 27, 2024 by PCI-DB Team

MikroTik RouterOS ARM Firmware 6.37.1 Description

IMPORTANT! DFS CHANGES:

- DFS configuration in RouterOS has been redesigned, now device looks at specific country settings (/interface wireless info country-info), and applies corresponding DFS mode for each frequency range automatically, making dfs-mode setting unnecessary.
- Please, check that your frequencies work with corresponding DFS settings before upgrade.

What's new:

- package - fixed wireless package status after upgrade to 6.37 (extra reboot after upgrade is necessary);
- ssl - fixed peer address/dns verification from certificate (affects sstp, fetch, capsman);
- winbox - now Winbox 3.6 is the minimum version that can connect to RouterOS;
- console - fixed typo in web-proxy (passthru to passhtrough);
- export - do not show mac-address in export when it is not necessary;
- firewall - fixed dynamic dummy firewall rules appearance in raw tables;
- hotspot - fixed nat rule dst-port by making it visible again;
- led - fixed default led settings for wAP2nDr2;
- snmp - do not allow to execute script if user does not have write permission;
- tile - do not reboot device after watchdog disable/enable;
- userman - always re-fetch table data when switching between different menus;
- userman - fixed timezone adjustment in reports;
- webfig - fixed channel selection in check-for-update menu in Firefox;
- winbox - added loop-protect settings;
- winbox - added passthrough state to web-proxy;
- winbox - allow to unset http-proxy field for sstp client;
- winbox - do not show health menu on RB951-2n;
- winbox - fixed typo in dhcpv6 relay (DCHP to DHCP);
- winbox - show address expiration time in dhcp client list;
- wireless - show DFS flag in country-info command output;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers