Draytek Vigor2820 Firmware 3.3.1.2 AnnexA 232201 Download

Posted at December 22, 2024 by PCI-DB Team

Draytek Vigor2820 Firmware 3.3.1.2 AnnexA 232201 Description

New Features:

Support ISDN function Improvement: VOIP: Add protect function for sending caller-ID with DTMF type for the character used is non-standardAdd protection for SIP parser to prevent malicious UDP 5060 port attackAdd an enable/disable check box in VOIP regionalAdd a telnet cmd "dtmftonepwr" for adjusting the power level of the DTMF tone sending PSTN switchSupport "ALL" interface in call barringSupport call pickup (when act as a caller)Improved: Danube DSP FXS on/offhook detection by using MPS driverImproved: Stability for FXO Port or PSTN Port ring detectionCorrected: wrong RFC-2833 packet was sent outCorrected: SIP SUBSCRIBE message missing "Contact" headerCorrected: VoIP can not change codec (driver layer)Corrected: when a phone call is rejected (486 message), it still plays ring back toneCorrected: DND exception list malfunctioningImproved: SIP/SDP parser to handle complicate SDP content.Improved: VOIP stabilityImproved: scenario for SIP ALG code for SIP client on WAN side registered to SIP server on LAN sideImproved: Digit-Map function can use different prefix length but start with same digit rule.Fixed: Problem of VoIP PSTN loopthrough in Phonebook and Digit Map3G: Improved: 3G reconnect stability, backup modeCorrected: unable to fetch 3G signal strength responseSupport SonyEricsson MD300 modem. Skip CSQ signal checkSupport Sierra 885/888 modem, DET-US3G5 modem, Cmotech D-50, and D-Link DWM-652 modemWireless: Set WPS client's default MAC address as 00-00-00-00-00-00 to avoid WUI display errorFixed: Problem that wireless clients are unable to get IP address from DHCPOthers: Corrected: IM-P2P can not block Vagaa applicationCorrected: WAN2 status not compatible with syslog utility 4.XCorrected: DDNS use WAN2 first fail.Corrected: syslog can not sent out via VPN tunnelCorrected: ways of handling DNS port reply packet (a non DNS answer packet)Corrected: IM-P2P mail alert malfunctionsImproved: VPN mechanism to avoid sending unnecessary DPD echo/replyImproved: FTP server (active mode upload)Improved: NAT loop back for SSH and FTP serviceImproved: handle protocol equal to zero packetsImproved: PPTP WAN mechanismImproved: telnet command for flush nat portmaps; it maybe useful for some conditions portmapsetting –fFixed: access control function can't be disabled in Wireless LAN>>Access ControlFixed: authentication failed with radius server: Vasco MiddlewareModify daylight saving table for New ZealandMake telnet Call-log related command more robust to prevent rebootRearrange the telnet command with alphabet order

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers