Gigabyte GA-C1037UN-EU (rev. 1.0) Intel RST Driver 11.5.4.1001 Download

Posted at November 21, 2024 by PCI-DB Team

Gigabyte GA-C1037UN-EU (rev. 1.0) Intel RST Driver 11.5.4.1001 Description

Specifications:

- CPU
Built in with an Intel Dual-core Celeron 1037U processor (1.8 GHz)
2 MB L3 cache

- Chipset
Intel NM70 Chipset

- Memory
2 x 1.5V DDR3 DIMM sockets supporting up to 16 GB of system memory
Dual channel memory architecture
Support for DDR3 1600/1333 MHz memory modules

- Onboard Graphics
Integrated Graphics Processor:
1 x D-Sub port
1 x HDMI port, supporting a maximum resolution of 1920x1200
Support for HDMI 1.4 version.
Maximum shared memory of 1 GB

- Audio
Realtek ALC887 codec
High Definition Audio
2/4/5.1/7.1-channel

- LAN
2 x Realtek GbE LAN chips (10/100/1000 Mbit)
Teaming is not supported.

- Expansion Slots
1 x PCI slot

- Storage Interface
Chipset:
1 x SATA 6Gb/s connector (SATA3 0)
2 x SATA 3Gb/s connectors (SATA2 1~2)
1 x eSATA 3Gb/s connector on the back panel
JMicron JMB368 chip:
1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices

- USB
Chipset:
8 x USB 2.0/1.1 ports (4 ports on the back panel, 4 ports available through the internal USB headers)

- Internal I/O Connectors
1 x 24-pin ATX main power connector
1 x 4-pin ATX 12V power connector
1 x IDE connector
1 x SATA 6Gb/s connector
2 x SATA 3Gb/s connectors
1 x CPU fan header
1 x system fan header
1 x front panel header
1 x front panel audio header
2 x USB 2.0/1.1 headers
1 x parallel port header
1 x serial port header
1 x Clear CMOS jumper
1 x chassis intrusion header

- Back Panel Connectors
1 x PS/2 keyboard port
1 x PS/2 mouse port
1 x D-Sub port
1 x serial port
1 x HDMI port
4 x USB 2.0/1.1 ports
1 x eSATA 3Gb/s connector
2 x RJ-45 ports
3 x audio jacks (Line In, Line Out, Mic In)

- I/O Controller
iTE I/O Controller Chip

- H/W Monitoring
System voltage detection
CPU/System temperature detection
CPU/System fan speed detection

- BIOS
2 x 32 Mbit flash
Use of licensed AMI EFI BIOS
Support for DualBIOS
PnP 1.0a, DMI 2.0, SM BIOS 2.6, ACPI 2.0a

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Intel Drivers