Buffalo TS-2RZH NAS Firmware 2.45 Download

Posted at November 21, 2024 by PCI-DB Team

Buffalo TS-2RZH NAS Firmware 2.45 Description

Fixes:

- Modified to deal with OpenSSL programming vulnerabilities (CVE-2014-3567 and CVE-2014-3568) that are also known as the POODLE (SSL3.0) vulnerability.
- Modified to deal with Samba programming vulnerabilities (CVE-2015-0240, CVE-2014-3493, CVE-2014-0244, and CVE-2014-0178).

Before updating the firmware:

- Please consult your local technical support representative if you experience any problems caused by this firmware update.
- Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
- USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.

How to Use Updater:

- Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
- Close all applications. Also, stop or exit any firewall software.
- Extract the downloaded file and run "TSUpdater.exe". When a TeraStation is detected, an update window will open.
- Select the TeraStation to update if multiple TeraStation are connected.
- Click "Update" and enter the TeraStation's admin password.
- Click "OK".
- Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
- When the update is complete, a message will be displayed

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Buffalo Drivers