Grandstream GXW4004 IP Analog Gateway Firmware 1.0.11.3 Beta Download

Posted at December 18, 2024 by PCI-DB Team

Grandstream GXW4004 IP Analog Gateway Firmware 1.0.11.3 Beta Description

Fixes:

- Fixed device trapped into reboot loop under certain conditions
- Fixed retrieving the empty upgrade server path via IVR caused device crash
- Fixed issue with upgrading from 1.0.9.x to 1.0.10.x when “Check New Firmware only when F/W pre/suffix changes” is checked
- Fixed Bridge mode performs DNS relay
- Fixed device sends Loop Current Disconnect for 4xx SIP responses
- Fixed HT503 FXO port cannot detect PSTN plugin
- Fixed HT503 FXS port analog phone dial *00 access to FXO port, analog phone hears dial tone and call waiting tone
- Fixed BroadSoft interop: DUT cannot switch between two lines after receiving server NOTIFY
- Fixed device have Dial tone after Current Disconnect instead of silence
- Fixed during call waiting, some abnormal operation causes some abnormal occurrence
- Fixed after upgrade the base image device get into waiting for upgrade to finish status
- Fixed if caller is not in transfer or hold or waiting status, Current Disconnect should able to work when caller's call setup failed
- Fixed SIP registration interval is not correct. Stopped failover processing if the initial registration try has not been done.

Enhancements:

- Added TR-069 support of moving FXS/Line from one profile to another. New gs_cpe version 1.0.1.42.
- Added support for SHA-256
- Added web UI Option "Add Auth Header On Initial REGISTER" under FXS port page (P value 2359/2459/2559/2659). If set to "yes", include authorization header in the Register request.
- Added a new option, when using DID to call, the From header is DID number. Added option "Use Request Routing ID in SIP Header" in web UI (P value 4891/4892/4893/4894). If enabled, the (SIP) User ID in the From header of an outgoing INVITE is replaced with the Request Routing User ID.
- Added option to remove PPI & Privacy Header. Added “Use Privacy Header” (P value 2338/2438/2538/2638) and “Use P-Prefer-Identity Header” (P value 2339/2439/2539/2639) in web UI.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Grandstream Drivers