Grandstream HT704 ATA Firmware 1.0.5.2 Download

Posted at November 23, 2024 by PCI-DB Team

Grandstream HT704 ATA Firmware 1.0.5.2 Description

Fixes:

- Fixed BroadSoft interop: device cannot switch between two lines after receiving server NOTIFY
- Fixed DNS Issue during Internet outage
- Fixed device continuously sends SUBSCRIBE SIP messages even though voicemail is disabled
- Fixed OnHook CAS and CID level is not in range of SIN 227 spec of -5.8dBm to -37.8dBm requirement, suggests -20dBm
- Fixed device cannot normally boot up if upgrade firmware together with configuration file via HTTPS
- Fixed device cannot boot up if it try to download the same version via HTTPS
- Fixed Internet light stays on after Ethernet cable has been unplugged
- Fixed device creates extra call object leading to one channel stuck in CALL_ENDING, causing no more incoming phone call unless device off/on hook
- Removed HTTP Access option from web UI
- Fixed IVR voice prompt does not read the correct IP address in certain scenario
- Fixed wrong order on Route header with ACK and BYE requests
- Fixed device rejects NOTIFY for UPnP Auto-provisioning. If NOTIFY is for multicast UPnP provisioning, device does not check to-tag
- Fixed in basic call conversation, after hold and resume, device keeps sending ReINVITE
- Fixed device makes anonymous calls under TLS mode, can cause CPU usage high and leads to abnormal behavior
- Fixed off hook CID silence time after the DTMF D ACK is 285ms-280ms
- Fixed UK – outbound call Ring back tone will have 440Hz overlap
- Fixed device does not support BT style MWI stutter dial tone
- Fixed inbound faxing with T.38 protocol having HDLC:fcs-BAD frames the SIP stack will stop working
- Fixed after listening voice mail the FXS LED still blinks
- Fixed device does not unsubscribe and re-subscribe if account information has been changed
- Fixed event lost during performance testing. Fixed a memory leak that occurs with the combination of MWI and ongoing call
- Fixed a crash problem caused by CANCEL on early media server while receiving 200 OK
- Fixed in new profile change the vocoder via IVR does not take effect
- Fixed device ringing didn't timeout
- Fixed device has Dial Tone after Current Disconnect instead of silence
- Fixed CPE doesn't report gateway related info in the TR-069 INFORM
- Fixed port in a response is not set properly if not explicitly specified in the Via header for TLS transport
- Fixed TLS block read issue where the read may not return the complete message
- Changed message receiving reassembling logic for SIP over TCP/TLS
- Fixed the problem when the device does not follow record route header route. This occurs when the route set is not empty and the request URI contains maddr parameter

New Features:

- Added option to remove PPI & Privacy Header
- Added Option "Add Auth Header On Initial REGISTER" under FXS port page (P value 2359 and 2459). If set to "yes", include authorization header in the Register request
- Added option for "Voice Frame per TX"
- Added option to disable the Hook Flash Function
- Added support for Voice Frame per TX in TR-069 Data Model
- Added the support for receiving TCP/TLS "\r\n" keep-alive messages

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Grandstream Drivers