VeEX CX180-D3+ Network Tester Firmware 5.5.2D3 Download

Posted at December 3, 2024 by PCI-DB Team

VeEX CX180-D3+ Network Tester Firmware 5.5.2D3 Description

Release Notes:

Cable Modem FW Version: 87.555mp10.010

SLM FW Versions:

CX180-D3+, CX150-D3+ (red plus), and CX100+ (red plus): 16.4; NXP 50.7 CX150-D3+ (legacy): 21.3

New features and improvements:

1. Ingress:
Adds ‘RP65’ mode for enhanced low level ingress detection, for the 5 to 65 MHz range.
Markers now support real time level updates.
2. Now supports new NXP based SLM board for units shipped from June 30, 2016.
3. TOA: supports new TLS 1.2 based websites.
4. Resolves occasional crash issue found with IP Tools.  

Note:

for CX150-D3+ (red plus), CX100+ (red plus), and CX180-D3+ units: after upgrading your unit to Version 5.5.2D3, there will be a prompt for a one time SLM FW update to version 16.4

About Device Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers