Gateway DX200 Marvell LAN Driver 8.27.4.3 for XP Download

Posted at December 26, 2024 by PCI-DB Team

Gateway DX200 Marvell LAN Driver 8.27.4.3 for XP Description

Specifications:

- Processor
Intel Celeron D
Intel Pentium 4
Level 1 (L1) Cache: 16 KB (all)
Level 2 (L2) Cache:
256 KB (Celeron D 3xx series)
1 MB (Pentium 4 5xx series)
2 MB (Pentium 4 6xx series)
Front Side Bus (FSB) Speed:
533 MHz (Celeron D)
800 MHz (Pentium 4)
Features (when supported by CPU)
XD (eXecute Disable) bit
EM64T (64-bit support) support
EIST (Intel Speed Step) support
HT (HyperThreading) support

- Chipset
Intel 915GV with ICH6

- System Clock
533 MHz (133 MHz × 4)
800 MHz (200 MHz × 4)

- Memory
Types supported:
400 MHz DDR2 SDRAM
533 MHz DDR2 SDRAM
Architecture:
Dual-channel DDR2 SDRAM
Slots:
Two 240-pin
Capacities:
128 MB non-ECC
256 MB non-ECC
512 MB non-ECC
1024 MB non-ECC
Minimum memory:
128 MB, single channel mode
256 MB, dual channel mode
Maximum memory:
2048 MB (2 × 1024 MB)
Network Controller Integrated 10/100 Marvell Ethernet

- Video
Integrated Intel Graphics Media Accelerator 900
1.3 GP/s pixel rate
333 MHz core clock
4 pixel pipes
VGA (standard) display support
Shared Video Memory
(Video Memory is Dynamically Allocated)
224 MB (when 512 MB system memory present)
128 MB (when less than 512 MB system memory present)
8.5 GB/s maximum memory bandwidth
Maximum resolution: QXGA 75 Hz (2048 × 1536)
Other features:
DirectX 9
Open GL 1.4
Hardware Motion Comp (HWMC) MPEG2 decode
Dual independent display support
Bob/weave De-interlacing

- Audio
Integrated Intel High Definition Audio using Realtek ALC860VU

- Add-in Card Slots
Two 120-pin PCI conventional
Bus speed: 33 MHz
Maximum speed: 132 MB/s uni-direction
Full height × 270 mm long
One 36-pin PCI-Express ×1
Bus speed: 2.5 GHz
Maximum speed: 500 MB/s bi-directional
Full height × 270 mm long

- Connectors
Rear External
One serial 9-pin connector
One parallel 25-hole connector
One video 15-hole VGA connector
One network adapter RJ-45 connector
Two PS/2 (keyboard and mouse) 6-pin mini-DIN
Four USB 2.0
Three audio 1/8-inch mini-jacks
Line-out (green)
Line-in (blue)
Microphone (red)
Front External
USB 2.0
Two audio 1/8-inch mini-jacks
Headphone (green)
Microphone (red)
Motherboard (internal) connectors
Two 7-pin serial ATA (SATA) 1.5 Gb/s connectors
40-pin primary IDE on PCI local bus. Supports up to two IDE devices
34-pin floppy disk drive connector
Three 4-pin fan headers for the rear and front chassis fans and the CPU fan (not used)
Two internal headers provide two ports per header (four connections total)

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Marvell Drivers