D-Link DCS-1130(L) IP Camera Firmware 1.08-8707 Download

Posted at November 21, 2024 by PCI-DB Team

D-Link DCS-1130(L) IP Camera Firmware 1.08-8707 Description

Release Note:

Enhancements:
1. Update Mydlink agent to v2.0.19-b14

Problems Resolved:
1. Fix POODLE security vulnerability by replace SSLv3 with TLSv1

How to update your camera firmware:

- Check your connections. Make sure your device is connected to your router with an Ethernet cable for the upgrade process. Do not use a wireless connection when upgrading the firmware.
- Also, make sure you use a computer connected to the same router as your device. Do not perform this process through a remote connection to your device over the Internet.
- Download the firmware to your PC and then unzip it if necessary.
- Open your device’s web interface. To do this run your device’s Setup Wizard and write down the IP Address for your device then write that IP Address into your web browser and login as admin with your password for it.
- Go to MAINTENANCE > Firmware Upgrade to go to the Firmware Upgrade page. Click “Browse” and then select the firmware file you saved and unzipped on your computer in the previous steps.
- After selecting the firmware file, click Upload to start the upgrade process.
- The upgrade process will begin, and will take about 2-3 minutes to complete. Do not start or use other applications while upgrading your device’s firmware, and do not hit Stop, Back, or Reload in your web browser during the upgrade process.
- Once the upgrade process is complete, click on the Firmware Upgrade link on the left to return to the Firmware Upgrade page.
- Verify that the Current Firmware Version matches the version of the firmware you uploaded. The upgrade process is complete, and you can close your web browser.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers