TRENDnet TEW-735AP (Version v1.0R) Access Point Firmware 1.02 Download

Posted at November 23, 2024 by PCI-DB Team

TRENDnet TEW-735AP (Version v1.0R) Access Point Firmware 1.02 Description

Installation notes:

- Right click on the downloaded file and select Extract All or Extract Here option. Make sure to remember the location where the extracted file is saved will be saved.
- Log into the TEW-735AP by typing http://tew-735ap or the IP address. The default IP address of TEW-735AP is 192.168.10.100
- Click on Management and then Firmware Upgrade
- Click Browse... and navigate to the folder on your computer in which the unzipped firmware file (.bin) is.
- Located and select it the firmware file.
- Click Apply.
- Wait until the firmware upload completed and the device reboot.
- The firmware upgrade is completed.
- Reset to Factory Default Settings

Note

:
Not all the configuration files can be carried over to different versions of firmwares. It is recommended that you reset configurations to factory default and configure you TEW-735AP from the fresh start again.

To reset TEW-735AP configuration back to factory default, click Reset in this page. All configurations will be set back to its original default settings.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related TRENDnet Drivers