NETGEAR GSM7328FS Switch Firmware 8.0.3.15 Download

Posted at November 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	NETGEAR GSM7328FS Switch Firmware 8.0.3.15
Category	Firmware
Manufacturer	NETGEAR
File Size	8.9 MB
Supported OS	OS Independent

NETGEAR GSM7328FS Switch Firmware 8.0.3.15 Description

Fixes:
- The user's MAC is not added into vlan assigned by radius when "dot1x port-control mac-based" enabled
- GSM7328Sv2/GSM7352Sv2 permits to download 7.x image.
- RPS when plugged in, always shows "powering" in "show hardware.
- Show tech-support output has several errors.
- SNMP Get next response has the same object name as Get next request.
- Device ignores the IGMP membership report with Source Address as 0.0.0.0.
- Lost access to switch's management interface intermittently.
- Copying files from USB to switch is too slow.
- Sensor information looks like incorrect in buffer log.
- When stack using AX741+AXM752, stack formed but devices connected to the switch cannot communicate.
- Incorrect IfOutDiscards is incorrect when port is down.
- GSM7352S crashed when the port for default route is disconnected.
- Two GSM7328Sv2 using 15 meter CX4 cable link between them will not link

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers