Posted at October 5, 2025 by PCI-DB Team
Install Driver AutomaticallyDevice Name | NETGEAR GSM712F Switch Firmware 2.4.1 |
---|---|
Category | Firmware |
Manufacturer | NETGEAR |
File Size | 1.5 MB |
Supported OS | OS Independent |
- Add IEEE 802.1w (Rapid Spanning Tree Protocol) support. The default mode for STP changed from IEEE 802.1d to IEEE 802.1w.
- Add support for EAP-TLS and EAP-TTLS for 802.1x Port Authentication.
- Add support for RADIUS accounting.
- Add support to allow range of IP address in host IP filter table or SNMP host table.
- Change the firmware upgrade procedure in Net-Save mode that the firmware will be downloaded and saved to the on-board Flash before the switch is rebooted. This solved the problem of upgrade failure when using fiber GBIC.
- Add a new control in SNMP access to allow read access to any host.
- Change SNMP read access from blocked to allowed by all hosts as default.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
Device Type: Router Switch Access Point File Size: 14.7 MB OS Independent
Install DriverDevice Type: Router Switch Access Point File Size: 30.9 MB OS Independent
Install DriverDevice Type: Router Switch Access Point File Size: 14.7 MB OS Independent
Install DriverDevice Type: Network Card File Size: 24.9 MB Windows XP ,Windows Vista ,Windows XP 64 bit ,Windows Vista 64 bit ,Windows 7 ,Windows 7 64 bit ,Windows 8 ,Windows 8 64 bit ,Windows 8.1 ,Windows 8.1
Install DriverDevice Type: Router Switch Access Point File Size: 26.3 MB OS Independent
Install DriverDevice Type: Firmware File Size: 18.9 MB Windows 9X ,Windows ME ,Windows NT ,Windows 2K ,Windows XP ,Windows 2003 ,Windows Vista ,Windows XP 64 bit ,Windows 2008 ,Windows Vista 64 bit ,Window
Install DriverDevice Type: Router Switch Access Point File Size: 14.7 MB OS Independent
Install DriverDevice Type: Router Switch Access Point File Size: 30.9 MB OS Independent
Install DriverDevice Type: Firmware File Size: 7.4 MB Windows 9X ,Windows ME ,Windows NT ,Windows 2K ,Windows XP ,Windows 2003 ,Windows Vista ,Windows XP 64 bit ,Windows 2008 ,Windows Vista 64 bit ,Window
Install DriverDevice Type: Network Card File Size: 20.2 MB Windows 9X ,Windows ME ,Windows NT ,Windows 2K ,Windows XP ,Windows 2003 ,Windows Vista ,Windows XP 64 bit ,Windows 2008 ,Windows Vista 64 bit ,Window
Install DriverFind Missing Drivers
Recent Devices
Recent Drivers
© 2025 PCI-DB.com - PCI Database Replacement. All rights reserved.