NETGEAR WNR1000v1 Router Firmware 1.0.1.15 (NA) Download

Posted at May 2, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	NETGEAR WNR1000v1 Router Firmware 1.0.1.15 (NA)
Category	Firmware
Manufacturer	NETGEAR
File Size	2.4 MB
Supported OS	OS Independent

NETGEAR WNR1000v1 Router Firmware 1.0.1.15 (NA) Description

Fixes:
- Traffic meter for PPTP and PPPoE connection type
- Supports parental control (requires PC based utility.)
- Supports multi-language within the same router GUI
- A language selection drop down list is added to the top-right corner of the router GUI. 
- Switching from non-English language requires valid Internet connection to download that language file.
- Exception: If non-English language is previously downloaded, user can switch to that language even after factory default reset
- The "Firmware Upgrade" check will check both the latest firmware and latest language file.
- Fixed NAT hairpinning issue
- Fixed “eMule running on LAN PC gets low ID”
- Fixed “static route can not work if the destination IP/subnet are on the LAN side.”
- Fixed “Blackberry 8820 can not connect to WNR2000 if the wireless security is WPA-PSK/WPA2-PSK mixed mode”

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers