NETGEAR JWNR2000v2 Router Firmware 1.0.0.9 Download

Posted at December 3, 2024 by PCI-DB Team

NETGEAR JWNR2000v2 Router Firmware 1.0.0.9 Description

Fixes:

- Added pre-set SSID and Passphrase feature.
- Added WPS 2.0 feature.
- DynDNS: only supports www.DynDNS.org.
- Take off "Trust IP Address" in QoS.
- Take off Traffic Meter, and Guest Network feature.
- Fixed igmp proxy bugs: igmpv3 didn't ignore upstream member report.
- Modified to send broadcast ACK if received DHCP Request had BROADCAST flag. To fixed Netger WNCE2001 and WNCE3001 DHCP failure issue.
- Refine PPP behavior for RU BT issue: do LCP echo reply in kernel space to avoid echo reply time out problem in heavy traffic.
- Enable wpa security in wds mode (only for PR)
- Refine QoS bandwidth detection algorithm to make it mush more accurate.
- To avoid some abnormal PPPoE sever in China, we limit sending PADT to only 2 times.
- Add RU ISP collect-info feature.
- Changed to use new algorithm for uplink bandwidth detection.

Note:

- Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.
- The upgrade process is completed when the on screen progress bar completes. If power LED light turns amber and blinking, power cycle the router to complete the upgrade.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers