NETGEAR DGND3700v2 Router Firmware 1.1.00.12 (WW) Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	NETGEAR DGND3700v2 Router Firmware 1.1.00.12 (WW)
Category	Firmware
Manufacturer	NETGEAR
File Size	17.9 MB
Supported OS	OS Independent

NETGEAR DGND3700v2 Router Firmware 1.1.00.12 (WW) Description

Fixes:
- QOS: set the QOS rule port as UDP port, then in the edit page, the start and end port displayed as empty.
- QOS: set rule's category as application, in the edit page, only part of applications were displayed in applications box.
- USB: when set HTTPS via internet port as invalid values, the warning message said port should be 80 or 1024 to 65534, the port 80 should be 443 instead.
- USB: HTTPS via port can be set as 80, but user can't access USB folder through port 80.
- Traffic meter: when set monthly limit as control by time, in statistics, the "connection time" should be "connection time left".
- USB: DUT should not allow the share name to be set as the same.
- USB: DUT allow folder name to be set as the same, but when folder name were set as the same, only one folder can be seen in \\readyshare.
- USB: when edit the folder name as space keys, there pop up a warning message said that share name can't be blank, the warning message is not right.
- IPV6: MTU: the MTU for IPV6 PPPOE is 1500.
- IPV6: when prefix length is less than 64, DUT should change the prefix length to 64.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers