Planet WDAP-W7200AC Access Point Firmware 1.3465cb151225 Download

Posted at November 24, 2024 by PCI-DB Team

Planet WDAP-W7200AC Access Point Firmware 1.3465cb151225 Description

Release version:

- Supported AP Controller V1.342c160114.

NOTE:

1. This firmware is only for the WDAP-W7200AC. A different firmware cannot be used for a different version. Thus, the WDAP-W7200AC's firmware only can be used in the corresponding models.
2. If any default value has been changed/customized in new firmware version, user must upload the "config-xxx.dat" (xxx is the build number)
file to apply the new settings after finished firmware upgrade.

Upgrade Method

1. To upgrade the firmware of your AP, please logon to the machine and click on the "Management" menu.
2. Then, choose "Upgrade Firmware".
3. On this page, you can use the Browse button to allocate the firmware bin file on your PC.
4. Once the new firmware file is selected, click the "Upload" button to start the upgrade process.
5. After the upgrade is completed, please navigate to "Reload Settings" page and then click "Browse..." button.
6. Select the "Config" file, click the "Upload" button to load the customized settings.
If your country conforms to the FCC regulatory, please reload the config of FCC, otherwise, please reload the config of ETSI.
7. After finished, please reset the AP to default setting and re-configure your AP. (Management-> Reload Settings-> Reset Settings to Default)

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Planet Drivers