NETGEAR DGN1000v3 Router Firmware 1.0.0.20 Download

Posted at March 3, 2025 by PCI-DB Team

NETGEAR DGN1000v3 Router Firmware 1.0.0.20 Description

New Features & Enhancements:

- Updated Firmware for compliance to the new regulatory EN300-328.1.8.1
- Changed the language version to 1.0.0.12

Bug Fixes:

- Keeps only the last email content in dead letter file when email cannot be sent
- Disabled SSL2 and SSL3 which has POODLE vulnerability issue
- Applied patches for Adaptive to Realtek
- Corrected PPPoA/PPPoE password has to be hidden, but changes to text mode when you focus on
- Port Forwarding should be able to accept the different external port mapping to the same internal port
- Modified the wizard for DHCP server detection.
- NAT function is only performed for the devices which are on the router’s LAN side and have the same subnet address as the router’s LAN
- Fixed SOAP SSID/Key setting for XSS protection mapping 8 special words
- Fixed the Attached Devices page cannot show connection type when device connected to guest network
- Fixed PPPoA mode, the "Round up data volume for each connection by" field will gray out issue

Known Issues:

- The Windows/MAC Genie application will scan devices (by sending ARP packets) and update the network map automatically. It will cause some wireless devices show as wired connection type for a while (until the application update the network map from the router).
- Sometimes the attached devices feature cannot get some wireless devices. (It caused by ARP packet loss).

To Upgrade:

- Download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is DGN1000v3-V1.0.0.20_0.0.20.img
- Using a web browser, login to the router as admin.
- Under Maintenance click Router Upgrade.
- Click Browse and locate the upgrade file DGN1000v3-V1.0.0.14_0.0.14.img.
- Click Upload.
- Wait for the upgrade progress bar to complete and final prompt to appear.
- If problems occur after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Test LED blinks (about 5 seconds). Then reenter your configuration information manually

Note:

- To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers