Netgear WAG511 Driver 3.1 Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Netgear WAG511 Driver 3.1
Category	Network Card
Manufacturer	NETGEAR
File Size	4.7 MB
Supported OS	Windows 9X ,Windows ME ,Windows NT ,Windows 2K ,Windows XP

Netgear WAG511 Driver 3.1 Description

NETGEAR has been a worldwide provider of technologically advanced, branded networking products since 1996. Our mission is to be the preferred customer-driven provider of innovative networking solutions for small businesses and homes.


Improvements

1. Fixed issue connecting to access points that use Broadcom chipset and with access control list enabled
2 . Fixed wireless noise issue
3 . Allow enable/disable Autocell without restarting computer

Limitations and Issues

1. When connecting to with Netgear ME102, after changing from WEP to no WEP or from no WEP to WEP, ME102 need to be rebooted for the WAG511 to re-connect
2. When using WPA(TLS/PEAP) or 802.1x(TLS/PEAP) under XP system, user must remove DNE(Deterministic Network Enhancer) service first or upgrade service pack to SP2
3. In Ad-Hoc mode, cannot change channel in 802.11a. The channel selection is automatic

Installation Instruction

1. Download the ZIP file, below
2. Extract the setup.exe file from the ZIP file to a convenient location such as the desktop
3. Unplug the WAG511 adapter from the computer
4. Run setup.exe
5. Select Reinstall/Repair, click Next
6. Select the your Country Domain, click Next
7. Click OK at the Country Domain Selection warning
8. Click Yes to the License Agreement
9. Click Finish
10. Plug in the WAG511 adapter
11. Click Next to start the Found New Hardware Wizard
12. Click Finish when Found New Hardware Wizard is completed
13. To check if the upgrade is successful, double-click the WAG511 icon on the system tray and click on the About tab. Driver version should be 3.1.1.754. AutoCell version should be 1.1.0.39. Smart Wireless version should be 3.1.2.0

Note! This is the driver only. If you need the manual, Acrobat reader or other, install the CD first.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers