Ubiquiti UAP-AC-PRO Access Point Firmware 3.7.5 Download

Posted at December 3, 2024 by PCI-DB Team

Ubiquiti UAP-AC-PRO Access Point Firmware 3.7.5 Description

UniFi Controller Changes:

- Updated the entire UniFi UI.
- Web UI is now mobile friendly.
- New AngularJS Hotspot Portal editor.
- Add controller preferences.
- Add site overview, for all sites configured within the controller.
- Add show system config function - simple overview of site configuration.
- Make many changes, and apply once config style.
- Add web based debug terminal (SSH terminal) for some UniFi hardware.
- Add Insights > Audio Streams
- Change Rogue APs to Neighboring Access Points.
- Add option to customize displayed columns.

UniFi Controller + UniFi UniFi AP AC-Lite/AC-LR/AC-Pro/AC-EDU Changes:

- Add RADIUS controlled VLAN support.
- Add Airtime Fairness (ATF) support.
- Enable DFS for approved countries (US/CA not approved yet).

UniFi Controller + UniFi Security Gateway Changes:

- New DPI view, found under Insights
- Add manual Site to Site VPN configuration option under Settings>Networks (currently in beta form)
- Add Smart Queue QoS
- This is the same implementation as in EdgeOS. Currently phase 1, which is simply WAN speed. Will add advanced options in future.
- Do note, that when this is enabled you will not be able to use DPI as traffic will not be offloaded.
- Maximum throughput will be affected as traffic is not offloaded. There is a rough guide in the above article.
- Add option to remap VOIP port as WAN2 on USG (UGW3).
- Add configurable options for LAN2 for USG-Pro. No need to enable VoIP anymore (actually not an option anyway).

UniFi Controller + UniFi Switch Changes:

- Add 802.1x support, along with RADIUS VLAN support.

Other Changes:

- [UAPG2] Limit bandsteering debug terminal to local host.
- [UAPG2] Improve 2G HT40 performance.
- [UAP+G2] Rate selection improvements.
- [UAP+G2] Various backend stability changes.
- [UAP+G2] Fixed a couple of memory leaks.
- [USG] Revert QUIC bypass patch.
- [USG] Revert to spin_lock as export function isn't used on USG.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers