NETGEAR DGN2200v4 Modem Firmware 1.0.0.46 WW Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR DGN2200v4 Modem Firmware 1.0.0.46 WW Description

Changes & Enhancements:

- Adds WPA2-enterprise 802.1x.
- Uses a new quick scan table.
- Fixes auto reboot when the Internet settings are applied.
- Disables the UPnP function by default.
- Removes the WDS repeater function from the GUI.
- Improves the auto scan algorithm to reduce the auto detection time.

Bug Fixes:

- The connection is blocked once traffic meter limit is reached. Disabling TM through NETGEAR Genie won't re-open the connection.
- The PPPoE MTU default is wrong.
- QoS does not work.
- [Port forwarding] The Move feature cannot detect an invalid value.
- [Access control] The Cancel button on the 'Add Allowed Device' page does not work.
- The outbound rule can't display after adding a port forwarding with the same port.
- The Router LAN IP can be set with a Block site trust IP, which is wrong.
- The security option 'WPA-PSK[TKIP]+WPA2-PSK[AES]' can’t be set successfully if genie is accessed from an iPad.
- DMZ server can be set as 192.168.0.1

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers