Bosch Security Autodome IP 5000 IR Camera Firmware 6.21.0008 Download

Posted at November 23, 2024 by PCI-DB Team

Bosch Security Autodome IP 5000 IR Camera Firmware 6.21.0008 Description

AUTODOME IP 5000 IR

- High-performance HD outdoor PTZ dome camera with integrated IR illumination for scenes with low or no ambient lighting
- Choice of HD resolution (720p25/30 or 1080p25/30)
- Long distance illumination up to 180 m (590 ft) allows easy detection and following of moving targets
- Variable illumination ensures that IR light is uniformly distributed in the field to avoid dark spots or over illuminated scene
- Superior privacy masking to safeguard the privacy of individuals

Changes:

- An issue with increased noise and thereof increased bit rate from AUTODOME and MIC cameras has been fixed.
- Auto Focus accurateness on DINION IP bullet 4000 and DINION IP bullet 5000 has been improved.
- An issue with fragmented EAP-TLS transfer has been fixed, allowing support for Microsoft Windows NPS and RADIUS.
- An issue with ONVIF Analytics Service has been fixed.
- GUI translations and some embedded help files have been updated.
- An issue with analogue output flickering on DINION IP starlight 7000 and FLEXIDOME IP starlight 7000 in 1.3 MP mode has been fixed.
- Wrong wording on time protocol settings has been fixed.

Note:

Due to an internal file system being introduced since firmware 6.1x and architectural changes thereof, an upgrade to firmware 6.20 and higher is only possible from firmware 6.1x versions or higher. Cameras with previous firmware versions below 6.1x first need to upgrade to firmware 6.1x.

Note:

Since firmware 5.92 no Autoload Decoder can be installed from the camera anymore. This video decoder, used in browsers to view the video stream, had to be taken out of the firmware content due to size limitations, favouring the new features. Instead, a download link to get the more feature-rich MPEG-ActiveX has been inserted, requiring Internet access for immediate installation.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Bosch Security Drivers