Stealth Cam STC-GX45NG Camera Firmware 01.34.09 Download

Posted at December 22, 2024 by PCI-DB Team

Stealth Cam STC-GX45NG Camera Firmware 01.34.09 Description

Firmware Update:

Note: It is recommended to perform the firmware update using new batteries. Loss of battery power during the firmware update may cause the camera to be non-operational.
1. Unzip the GX45NGW (v01.34.09).zip file.
2. Once unzipped, place the Firmware Update File listed below onto a clean SD Card.
3. Place the SD Card into the SD Card slot of the camera.
4. Turn the camera to the ON position.
5. Press the MENU button.
6. Press the down arrow to select Advanced Settings then press ENTER.
7. Press the down arrow to select Software Upgrade then press ENTER.
8. Press the up arrow to select Yes then press ENTER.
9. The update process will begin and takes approximately 1 minute to complete. The screen will display FW UPDATE during the update.
Warning: Do not turn camera off or eject battery tray during the firmware update process. Loss of power to the camera may cause damage.
10. After the update process is complete, the LCD screen backlight will turn off and the screen text will be removed from the screen.
11. Slide the switch to the OFF position and eject the battery pack from the camera.
12. Wait 5 seconds before re-inserting the battery pack.
13. Re-insert the battery pack and move the switch to the TEST position.
14. The screen will display the FW Versions below.

About Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Stealth Cam Drivers