NETGEAR D6300 Modem Firmware 1.0.0.88 WW Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR D6300 Modem Firmware 1.0.0.88 WW Description

Enhancements and Changes:

- Updated FW for compliance to the new regulatory EN 300 328 and EN 301 893
- Added device mode.
- No reboot while setting “Internet Setup”, “ADSL Setup” and Setup Wizard.
- Updated PVC quick scan table.

Bug Fixes:

- Port Forwarding: When disable(delete) an Inbound Firewall Rule and then enable(rebuild) it, It will not work,Unless reboot the router
- Diagnostics: Nslookup result is a IPv6 address
- Genie: Genie ReadyShare page cannot open
- QoS: Added a priority for MAC address GUI is error
- Port Forwarding: No warning message when move position is error
- D6300 - no internet access on 5 GHz guest network, DNS IP address must be set manually
- Setup wizard page error when router is connected to PPTP server
- DNS display issue
- Can't visit internet when connection mode is static ip address through setup wizard
- To ping IPv6.google.com in 6 to 4 mode fail after 2 hours
- Recurrence pattern doesn't display fully
- After enabling parental control, advanced page still displays the previous DNS.
- QoS rule of Ethernet LAN port doesn't work
- Sending logs to syslog server not working (Block site log)
- Sending logs to syslog server not working
- Unable to access the wireless settings and Guest settings after updating the NETGEAR Genie app.
- Netgear genie app on apple mobile device has no access to router settings
- Fixed the issue that Genie cannot detect new firmware.
- Fixed the issue that Genie cannot support 5GHz part.
- Warning message is incorrect in port triggering
- USB printer issue
- GUI doesn't auto skip to "Rebooting the router now, please wait…" page when configuring v6 as Fixed
- Connection Status page displays too small to see the buttons in this page in DHCP mode
- Pop up error message when set valid interface ID
- Some issues about GUI - WiFi schedule page
- GUI displays as 'Unknown Error: 1' when upgrading the firmware with incorrect size.
- LAN PC can ping primary WAN IP when plug out WAN wire with DHCP mode and DNS displays abnormally in some cases
- Fixed once traffic meter limit is reached, connection is blocked, disabling TM through NETGEAR Genie won't re-open the connection. Click [Apply] button in router web GUI can make the router reconnect to internet again.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers