NETGEAR FSM7326P Switch Firmware 6.1.0.9 Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	NETGEAR FSM7326P Switch Firmware 6.1.0.9
Category	Firmware
Manufacturer	NETGEAR
File Size	6.8 MB
Supported OS	OS Independent

NETGEAR FSM7326P Switch Firmware 6.1.0.9 Description

Fixes:
- Port description feature to allow description be added to each port
- Add support for new switch model GSM7328FS
- Add “show mac-addr-table <vlan id>” command that shows mac addresses learned per VLAN
- The “show mac-addr-table” command now supports '<mac-addr>' option without requiring <vlan id> option
- Add “configure terminal” command which works the same as “configure” command
- Logical Interface name (e.g. “vlan <id>”, “lag <id>”) display changes missing in some CLI commands.
- SNMP MIB objects, etherStatsOversizePkts, etherStatsJabbers, SyRmSnRmEs, are not functioning properly.
- Port Config pop menu fails in JRE 1.6.0
- GSM73xxS: IGMP snooping not working
- Configuration script file could not be executed completely with certain configuration
- DHCP server client config show run output has bad client-identifier
- Rebooting when building 200 neighbors and receiving 2 routes from each neighbor
- GSM73xxS: Fan Status always reported as OK in show hardware output
- FSM73xxS: Diffserv Class with matching condition mac address and mask is not working.
- DHCP client: switch crashes while obtaining address from server
- SNMP SET operation not being done properly on the object - 'agentStpConfigRevision'
- RIP: wrong route will be sent when changing its subnet mask frequently
- GSM73xxS: 10G fiber ports showed media type as copper
- GSM73xxS crashes when enable/disable OSPF on the remote end more than 2 times
- SNMP: configuration script contains SNMP setup would fail to apply
- FSM7328S crash with banner file download
- SNMP: command 'no snmp-server community ipmask 255.0.255.0' failed
- SNMP: command line inconsistent with running-config
- port-channel static should be configured in "interface lag <lagid>" mode

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers