NETGEAR WC9500 Wireless Controller Firmware 4.1.0.13 CN Download

Posted at November 21, 2024 by PCI-DB Team

NETGEAR WC9500 Wireless Controller Firmware 4.1.0.13 CN Description

Bug Fixes:

- AP reboot fixes
- Fix for frequent wireless client reconnect for WNAP210v2
- RFID data forwarding issue fix for WNDAP380R
- Fix for beacon stuck issue
- Showing AP uptime in the UI
- Fix for AP reboot issues reported by WC9500 products customers
- RFID process crash causing AP reboot fixed
- L3 roaming fix
- Captive Portal fix: For some instance the captive portal page is not showing up, but still the wireless clients can access Internet
- 10G interface fix
- Beacon interval changes
- Fixed SNMP daemon crash issue
- AP reboots changes ported from 7600
- Staggering beacons changes added
- Neighbor AP list was not sent to controller when Rogue detection was disabled
- Changes for setting beacon interval dynamically based on the number of profiles configured for a group. Beacon interval of 320ms for groups with more than 4 profiles and 100ms for groups with less than 4 profiles
- RFID Serial comm crash fix. Array out of bound write issue fixed
- When more than one ACl group is present and if any one of them is with no mac
- Client IP and VLAN values getting reversed
- Unable to configure Controller name more than 15 char
- AP channels are not displayed properly in Monitor Access Point page
- Fix For memory leak during L3 roam

Known Issues:

- Initial firmware upgrade from M1 (3.1.x.x) image, (one time for WC9500 M4 beta) needs to be done using TFTP or FTP method in Maintenance > Upgrade.
- Radius proxy server in wireless controller may not work, if there are managed AP’s in down state and its last known IP address matches with one of the connected and up AP in the same wireless controller.
- SNMP traps are not supported in WC9500 M4 beta firmware.
- Wireless client separation feature do not work when clients are connected on different AP’s on same profile.
- Inconsistency in L2/L3 discovery for AP’s.
- By running the L2/L3 discovery multiple times, user can discover all AP’s.
- Captive portal unauthenticated clients can able to send and receive multicast traffic.
- Captive portal authenticated clients require re-authentication when roaming from Master Controller managed AP to Save Controller managed AP or vice versa.
- Wireless fixed data rate setting for WNDAP660/WNDAP620 will not be supported.

Upgrade Instructions:

- Download and extract the new software to a convenient place such as your desktop.
- Log into the WC950
- Select Maintenance > Upgrade from the main/submenu.
- In the Firmware Upgrade section, select Local File and click Browse.
- Locate the downloaded file and click Apply.
- This will start the software upgrade to your WC9500. This may take some time. Do not interrupt the upgrade process.
- You have use TFTP/FTP method if the current image version is 3.1.x.x.
- At the conclusion of the upgrade, your WC9500 will reboot.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers