CradlePoint IBR1150 Router Firmware 5.3.0 Download

Posted at December 25, 2024 by PCI-DB Team

CradlePoint IBR1150 Router Firmware 5.3.0 Description

New features added in this release:

- VLAN Redesign under Network Settings / WiFi / Local Networks / VLAN Interfaces. This includes VLAN support for WAN interfaces.
- HTTP Proxy support was added under Network Settings / Content Filter / Upstream Proxy Settings. Proxying HTTPS traffic will not work transparently.
- ZScaler Internet Security added to the Network Settings / Content Filter / Cloud Based Filtering/Security page.
- LLDP support is added under System Settings / Administration / LLDP. It can be enabled for WAN or LAN, and devices that are discovered are shown under the Status / LLDP page.
- Additional options are added to the System Settings / System Control / Ping Test to be able to set the Packet Size and Don’t Fragment.
- Additional options are added to traceroute, including MTU discovery and a number of other features.
- Allow SNMP traffic on the WAN interface when IP Passthrough mode is enabled.
- Modem Multi-Carrier Software Switching. Allows for switching of modem firmware from one North American cellular carrier to another North American cellular carrier.
- Smart Operator Selection. Extension of this IBR6x0P feature to more models. When this feature is enabled and when used with a globally-provisioned SIM, the router scans for available mobile broadband networks then selects the best network based on user-configurable values.

Additional UI/Usability changes:

- MAC Address filtering by range, allowing a range of MAC Addresses to connect to the router instead of entering multiple host MAC Addresses.
- SNMP Password requirements when the router is in Advanced Security Mode are the same as for the Administration Password.
- Removed ZScaler from the Enhanced Enterprise License.
- Modified underlying attempts and retries for more successful Sprint LTE activation results.

Defects fixed:

- Ethernet port auto-negotiation. Link speed configuration has changed to set the Ethernet port link speed to the specified value instead of auto-negotiation plus advertisement of a single link speed. If an existing configuration relied on auto-negotiation plus advertisement of a single link speed, the link might not come up depending on the connected third-party hardware.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related CradlePoint Drivers