Ligowave LigoPTP RapidFire Firmware 7.53-2 Download

Posted at December 22, 2024 by PCI-DB Team

Ligowave LigoPTP RapidFire Firmware 7.53-2 Description

Changes:

New:
- Added Idle/Active operation states, which balance between low latency and high throughput

Improvements:
- Improved link stability and performance in low temperature environment
- Applied DFS FCC waveform tuning

Fixes:
- Fixed GUI issues when CT country configured with more than 31 dBm gain
- Fixed TX leakage in DFS channels

About Range Extender Firmware:

If you intend to apply this firmware, first go to the system information page of the extender and make sure that the currently applied version isn’t either newer or matching this release; you should get the downloadable package only after you have done this.

Updating to a new firmware can resolve vulnerability problems, fix various compatibility issues, enhanced existing features, correct different language-related errors, and improve overall performance and stability.

As for the installation steps, since there are numerous extender models, it would be best if you read and, above all, understand the update procedure before you proceed to applying the new firmware; this holds true even if you are a power user.

Bear in mind, that during the upgrade, you mustn’t use the device’s buttons or interrupt the process in any way. Doing so can cause serious malfunctions to the wireless extender.

Therefore, if this firmware satisfies your needs, get the desired version, and install it to your system; if not, check with our website as often as possible so that you don’t miss the update that will improve your device

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ligowave Drivers