NETGEAR SRX5308 Firewall Firmware 4.3.3-3 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR SRX5308 Firewall Firmware 4.3.3-3 Description

Fixes:

- WAN1 is getting down and come up after two days running traffic in load balancing mode with customer configuration file.
- Unable to make multiple calls from WAN to LAN using SIP.
- Fixed SSL VPN ActiveX certificate expired.

Known Issues and limitations:

- Not able to establish IPv6 SSL-VPN tunnel from java based browsers with java 8 update 20 version.
- Unable to run the FTP traffic from FileZilla client over SSL Port forwading tunnel in the Windows7 64 bit host.
- Unable to establish port forwarding tunnel from Windows7 64 bit IE9 browser.
- Internet Traffic Statistics are not getting updated correctly in auto rollover mode
- NFS service support: Only support NFS v4 "mount" command, do not support NFS v2, v3 and "showmount" command.
- No NAT translation of SIP headers during REGISTER, outbound call and SDP.
- Observed inconstistant behaviour with voice traffic when server is lying in LAN and DMZ side.
- Unable to establish the fourth call from LAN side.
- Unable to establish the IPv6 manual tunnel with traffic selector as ANY/ANY.
- Able to Configure IPv6 Address pools and DMZ adverisements prefixes through CLI when DMZ is not enabled.
- [CLI]Firewalllogs6 table is not updating properly for enabling and disabling logs through CLI.
- Able to run Port triggering inbound traffic with the open port from any WAN hosts.
- Daylight saving functionality is not working for time zone "GMT-0"
- PPPoE over IPv6 WANs are getting restarted and IPv4 WAN is not responding after changing WAN mode for multiple times.
- Able to establish VPN gw-gw tunnel with mismatch user-FQDN and able to run traffic.
- Traffic is not following WAN upload or down load(higher one of them )speeds if the upload and down load speeds having large difference.
- Unable to establish L2TP connection from WAN secondary addresses fail.
- [IPv6]Unable to run the FTP ,http,iperf traffic on pppoe over IPv6 with DHCP option as "Disable-DHCPv6"
- Able to select same WAN for both primary and secondary WANs for auto rollover WAN mode in IPv4/IPv6 dual stack mode.
- Unable to get the IP to LAN host after rebooting the device continuously for over night.
- [IPv6]Displaying the message as address not found instead of 'Blocked from this Browser' for IPv6 policy 'Deny Login From Defined Browsers.'

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers