Hasselblad H3D Camera Body Firmware 2.2.4/16.0.6 Download

Posted at November 21, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Hasselblad H3D Camera Body Firmware 2.2.4/16.0.6
Category	Scanner Digital Camera Webcam
Manufacturer	Hasselblad
File Size	425 KB
Supported OS	OS Independent

Hasselblad H3D Camera Body Firmware 2.2.4/16.0.6 Description

Firmware version CB120131.hbf requires one of the following Hasselblad digital capture products: H4D, H3DII, H3D, H2D series.

Fixes:

- A bug which could cause incorrect angle measurements in True Focus to be applied after a lens change has been fixed.

Installation steps:

1. Remove lens and viewfinder and connect the camera to the host computer using a FireWire cable.
2. Make sure the computer is powered from the mains supply or has a fresh battery.
3. Start Phocus and when the camera is connected, as indicated by an active camera icon in the top left part of the screen, select “Update Firmware...” from the “File“ menu.
4. Browse to the location where the update file was saved and follow the instructions on screen.
5. The update procedure will take a few minutes to finish. Depending on camera model, different options will be available during the update process.

Important notice:
- This firmware is not to be used with H1, H1D, H2 or H2F.
- Firmware updating is only possible via Phocus version 1.1.3 Mac, 1.0.2 Windows (or later).
- Do not use a PC laptop to perform this firmware update, as the firewire providence (it’s ability to provide enough power) may be to low. Attempts may render the sensor unit un-bootable. Should you experience this problem then perform the update on a stationary PC. This problem is not related to Mac computers.

About Digital Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance.   

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Hasselblad Drivers