NETGEAR WMS5316 Wireless Controller Firmware 2.1.4.15 Download

Posted at December 19, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	NETGEAR WMS5316 Wireless Controller Firmware 2.1.4.15
Category	Firmware
Manufacturer	NETGEAR
File Size	6.7 MB
Supported OS	OS Independent

NETGEAR WMS5316 Wireless Controller Firmware 2.1.4.15 Description

Fixes:
- Add WNDAP360, WNAP320 support for WMS5316.
- Remove WNDAP330/ WG302v2/ WN802Tv2/ WG602v4 support for WMS5316 V2.1.2
- Allow discovery of multiple APs with factory default IP address and assign them new static IP when adding for management with WMS5316.
- Selectable Corporate Channel List for Auto Channel Selection
- Wireless page configurations to be allowed with central CA also. Radio page should be configurable even with Central CA.
- Fix for onsite customer issue - tunnel flap (display issue) when there is heavy data traffic.
- Fix for that not show rogue AP list on monitor page when rogue AP is disabled.
- Fix for alternate AP getting to disconnected state when 16 Ap's are added in.
- Fix for Rogue AP configuration getting disabled even though it is configured as enabled and WMS is rebooted
- Fix for Extra Junk Character being sent along with 64 character key.
- Fix for Shared Secret Key in length Radius Server getting truncated to 32 when sending the configuration to AP.
- Fix for SNMP community string different then "public" are not discovered.
- Fix for Bug - WNAP210 AP model mismatch.
- Fix for UI Bug: IP Discovery not showing results until page refresh.
- Fix for bug that 5 GHz channel not populating in wireless page.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers