Cisco RVL200 Router Firmware 1.1.12.1 Download

Posted at December 3, 2024 by PCI-DB Team

Cisco RVL200 Router Firmware 1.1.12.1 Description

Resolved Issues:

- Corrected the expired certificate issue with the ActiveX components of Virtual Passage.
- Corrected a problem where Remote Management and SSL VPN cannot function properly in Router mode.
- Corrected a problem where Port forwarding cannot be configured properly if the router's LAN IP is 192.168.0.1.
- A Port for SSL VPN can now be configured using the Web User Interface.
- SSL VPN and Remote Management can be managed (enabled or disabled) separately.
- Corrected the problem causing Syslog to stop working after the router has been up for a few days.
- Now supports SNMP sysObjectID.
- Port Forwarding supports multiple subnets. For details, please refer to Setup -> Forwarding in the Web User Interface.
- Now supports Custom DynDNS.
- Corrected an issue where a SNMP OID is shown incorrectly in the Default View of the SNMP tab of the Web User Interface.
- Corrected a problem where the router password does not save correctly when the password contains the bracket characters ] or [.
- Corrected a SIP ALG interoperability issue with SPA8000, causing errors in Network Address Translation and headers becoming distorted.
- Corrected a SIP ALG issue with SIP re-invite.
- Corrected a Diagnostics problem causing a Ping from a router not being able to reach the router's WAN IP

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers