Cisco RV180W Router Firmware 1.0.5.4 Download

Posted at December 22, 2024 by PCI-DB Team

Cisco RV180W Router Firmware 1.0.5.4 Description

Enhancement:

- Support the free DDNS, no-ip.com.
- Enhance the daylight saving time configuration.

Issues Resolved:

- The ‘NO CONNTRACK FOUND’ message repeated in the syslog when Kernel Warning messages are enabled.
- FTP do not terminate the connection properly.
- The GUI and DHCP of RV180 becomes unresponsive after running for several days.
- In the IPv6 tunneling setting page, the Remote End Point can’t be enabled and set the remote IPv4 address.
- CoS to DSCP does not work.
- CoS to Queue with priority does not work.
- QoS scheduling by priority does not work.
- When the WAN connection type is set to PPPoE, the QoS rate limit does not work.
- QuickVPN tunnel is not established when the LAN IP subnet mask is 25 to 30 bits.
- Request to supporting the new DDNS service, no-ip.com to the RV180x platform.
- Can only manually set time to 2015 and lack the day of 29th day in February.
- Request to add the feature of daylight saving time setting.
- Unexpected to be opened pages can be opened using the PPTP connection.
- NAT between VLANs is running when PPTP server is enabled.
- Boot time is longer than the last firmware version

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers