Cisco RV220W Router Firmware 1.0.6.6 Download

Posted at December 22, 2024 by PCI-DB Team

Cisco RV220W Router Firmware 1.0.6.6 Description

Changes:

- Daylight saving time is not configurable for Manual Time Configuration.
- The rate of the WAN port do not match the configured rate limit of the QoS profile after binding with some services.
- The total WAN bandwidth can exceed the configured value in the QoS profile.
- The rate limit of the VLAN cannot work with the wireless clients who access the VLAN by SSID.
- Unable to filter or block the one to one NAT hosts via the Access Rules.
- The inter-VLAN firewall rules can not permit or block the inter-VLAN traffic.
- The remote management feature cannot work after upgrading from the firmware version 1.0.4.7 to 1.0.6.6.
- Fix the issue that the time configuration of the device can only be set till 2015.
- The warning message of invalid IP address pops out when that IP address is valid.
- The hosts which get the right IPv6 addresses from IPv6 Prefix Delegation cannot be connected to the Internet.
- The SSID authentication function will not work when EAP-TLS is used.
- Some of the QuickVPN users cannot connect to the device after running for a few days.
- Fix the referrer check of GET requests.
- Fix the input validation of cookies to improve the security of file uploads.
- Fix the command injection vulnerability.
- The web interface page is not redirected to the login page after time out if user refresh the page directly in the web browser.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers