Cisco CVR328W Router Firmware 1.02.02 Download

Posted at April 29, 2024 by PCI-DB Team

Cisco CVR328W Router Firmware 1.02.02 Description

The following new features and enhancements were added to firmware version 1.02.02:

- The MAC addresses of the network interfaces, including Ethernet WAN, LAN, WLAN, and USB dongle, are displayed on the GUI.
- Support the new DDNS providers: Oray and No-IP.
- Add the new feature of MAC Address Clone.
- The firewall can be enabled to block the ping requests from WAN.
- TR-069 enables the interoperability between Cisco Prime Home ACS and RV315W. WAN configuration, firmware upgrade and downgrade, reboot, factory reset, and configuration file download can be operated on the device.
- Under the same site-to-site IPsec VPN policy, the user can define multiple interesting traffic flows (up to 50).
- Dynamically support new USB dongle by loading the driver files into the device.
- Support logging the USB dongle information.
- Add the new feature of multi-WAN health check.

The following issues were resolved in firmware version 1.02.02:

- Unable to upload the configuration file through the English web-based Configuration Utility with Mozilla Firefox 22.0 and Mac OS 10.6.
- The web page cannot display normally when the web site is added into the white list. After disabling the white list feature, the web page will display normally.
- The L2TP packet cannot go through the

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers