Cisco RV320 Router Firmware 1.2.1.13 Download

Posted at December 26, 2024 by PCI-DB Team

Cisco RV320 Router Firmware 1.2.1.13 Description

Enhancement

- Support new DDNS service No-IP.
- Support DDNS periodical update.
- DDNS support more flexible domain nam
- The IP and MAC binding table are sorted by the IP address.
- Support configurable VLAN ID range 2-4092.
- Support configurable TCP/UDP session timeout.
- Add reset button in traffic statistics and system statistics page.
- Support hex type for option 82 circuit ID.
- Enhance the daylight saving setting.
- Support SSH access.
- Support CLI for LAN and ACL.
- Support SSL VPN virtual passage for Win7(64bit) IE10 and Win8.1 IE11.

Resolved Issues:

- Sometimes the DNS process is gone and can not reply to the DNS request from LAN network.(CSCus07365)
- UPNP does not work on non-default VLAN. (CSCuq40914)
- RV32x does not handle unsupported DHCP options. (CSCus23264)
- Critical error when more than 30 services in Service Management. (CSCuo71846)
- Sometimes the router will reboot after removing the 3G/4G USB dongle and receive the multicast traffic from LAN network. (CSCur98498)
- Hangs when using multiple VPNs. (CSCuo75962)
- DHCP doesn’t work if only enabled for one VLAN. (CSCut07168)
- Sequential IP addresses display in IP & MAC binding table view.(CSCut84147)

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers